美女胸被狂揉扒开吃奶的网站o_亚洲日韩av中文无码专区_东京热激情无码专区_久久HEZYO久综合亚洲色_欧美成人高清视频_国产精品乡下勾搭老头_欧美一级v片在线播放_成人午夜国产视频_男女猛烈无遮挡免费动态图_亚洲一区国产精品视频

1.5 CABLE FOR RS232, RS422, RS485 SERIAL DATA LINKS

Where cables are listed as being for RS422 or RS485 serial data links, cable classed as "Low

Capacitance Data Cable for RS422/RS485 Serial Links" is required, in accordance with the

following requirements:

Where cables are listed as being for RS232, cable meeting the requirements for RS422 and RS485

will be more than adequate. Since RS232 is generally unsuitable for other than short local links, it

is unlikely that special purchase of cable meeting only the requirements of RS232 data links would

be worthwhile.

Low capacitance Data Cable suitable for RS422/RS485 Serial Links- Cable Specification:

Construction : Conductors formed into twisted pairs, with single overall foil

screen and overall tinned copper braid screen, with overall

insulating sheath.

Conductors: Tinned Copper, stranded. For mechanical reliability,

22AWG/0.34mm2 is the recommended minimum conductor

size.

Number of twisted pairs required: As shown on Converteam interconnection diagrams.

(3 pairs normally required. 2 pairs for 2-wire RS 485, or

where data flow is in one direction only. One of these pairs

is required for the 0V connection.)

Circuit voltage: 24V

Characteristic Impedance: 100 W to 120 W.

Capacitance (maximum): 45pF/m between conductors of one pair.

75pF/m between one conductor and all others and screen

connected together.

Resistance (maximum) 80 W/km

Velocity of Propagation (minimum) 70%

Notes:

1) If any cable run will exceed 200m, contact Converteam - cable of lower capacitance may

be necessary.

2) Each cable should only carry one Serial Data Link.

3) When data flow is known to be in one direction only, requiring only one pair for data (e.g.

as in the case of printer connections), a 2-pair cable may be used, with the second pair used

as the 0V connection.

4) The number of pairs required will be indicated on Converteam Schedules/Interconnection

Diagrams.

The following cable types are known to have suitable electrical properties, but the Cable Contractor

must check that the cable construction and materials are acceptable for the application:

a) For four-wire links, using the third twisted pair as the ground connection between serial

ports: Belden type 3108A, (22 AWG).

Belden type 8103 (24 AWG),has suitable electrical properties but the conductor size is

smaller than recommended by Converteam, and may not be accepted by the Classification

Society.

b) For two-wire links, using the second twisted pair as the ground connection between serial

ports: Belden type 3107A, (22 AWG). Belden type 8102 (24 AWG) has suitable electrical

properties but the conductor size is smaller than recommended by Converteam, and may not

be accepted by the Classification Society.

求助大家?guī)兔�選一下,有沒有這方面的資料!

我們是國內最早生產RS485電纜的廠家之一。

---------------------------------------------------------------------

通用型現場總線系列電纜

      特性阻抗為120Ω的雙絞屏蔽電纜廣泛用于RS485/422、CANBUS等總線，該系列電纜規格很多，請?zhí)峁╇娎|的敷設環境、通信速率、最大無中繼傳輸距離等參數，我們將依照具體情況推薦最適當的產品。一般推薦如下：

     普通雙絞屏蔽型電纜 STP-120Ω（for RS485 & CAN） one pair 20 AWG ，電纜外徑7.7mm左右，藍色護套。適用于室內、管道及一般工業環境。使用時，屏蔽層一端接地！

      普通雙絞屏蔽型電纜 STP-120Ω（for RS485 & CAN） one pair 18 AWG ，電纜外徑8.2mm左右，灰色護套。適用于室內、管道及一般工業環境。使用時，屏蔽層一端接地！

鎧裝雙絞屏蔽型電纜 ASTP-120Ω（for RS485 & CAN） one pair 18 AWG ，電纜外徑12.3mm左右，黑色護套�？捎糜诟蓴_嚴重、鼠害頻繁以及有防雷、防爆要求的場所。使用時，建議鎧裝層兩端接地，最內層屏蔽一端接地！

好資料